Adjustment of cutting point of the stripper

1》 After the cutter die setting is completed, place the material to be cut on the rubber plate, then place the cutter die on the material, and then push the feed plate into the cutting area.
2》 Press the 12 cutting switch with both hands respectively. At this time, the cutting pressure plate will be lowered and pressurized on the cutter die until the cutter die automatically picks up to the position before starting after cutting off the material.
3》 When blanking materials, if it is found that the materials are not completely cut, adjust the 03 cutting depth controller and turn the "pressure system" clockwise and counterclockwise; If the knife mold is pressed into the rubber plate too deeply, turn the "pressure control" counterclockwise. The longer the adjustment time is, the deeper the cutting depth is. Try to adjust until the knife mold is slightly pressed into the rubber plate.
4》 Pull the feeding plate out of the cutting area, take out the cut material, and complete a blanking process.